Partial Replacement Of Sand With Copper Slag And Fly Ash

Partial Replacement Of Sand With Copper Slag And Fly Ash

  • Partial replacement of Fine aggreggate by Copper

    Partial replacement of Fine aggreggate by Copper Slag and Cement by Fly Ash 1. 1 Replacement Of Fine Aggregate By Copper Slag And Cement By Fly Ash Ammini College Of Engineering, Mankara, Palakkad 1. INTRODUCTION 1.1 GENERAL Concrete is the man made material widely used for construction purposes.

  • Partial Replacement of Copper Slag as Fine Aggregate

    copper slag. Fig.7. Comparison of Flexural Strength of Beam IV. CONCLUSION The concrete was prepared for the M 25 grade concrete with partial replacement of fine aggregate by copper slag with various percentages of 0%, 10%, 15% and 20%. The specimens were casted for 7days, 14 days and 28 days then tested. The results are presented above.

  • Effects of Copper Slag as Sand Replacement in Concrete

    fly ash, silica fume and slag are being used into construction industry as a partial replacement to the fine aggregate. Similarly copper slag is a by-product from copper industry which can be used as a sand replacement into concrete. II. MATERIALS AND METHODS

  • INFLUENCE OF COPPER SLAG AS PARTIAL REPLACEMENT OF

    INFLUENCE OF COPPER SLAG AS PARTIAL REPLACEMENT OF SAND IN CEMENT CONCRETE Suresh T, Ravikumar C observed that partial replacement of sand with copper slag has sound tensile and compressive stregth and it conference on fly ash, silica fume, slag, andnaturalpozzolans in concrete, SP 11482; pp 1677-95 .

  • Experimental Study on Partial Replacement of Cement by

    Experimental Study on Partial Replacement of Cement by Flyash and GGBS Syed Asif Ali1 College, Gulbarga, Karnataka, India Abstract— This paper presents a laboratory investigation on optimum level of Fly ash and Ground Granulated Blast Furnace Slag (GGBS) as a Locally available river sand which is free from organic

  • Mechanical Properties of Concrete with Copper

    This paper presents a laboratory study about the influence of combination of Fly Ash (FA) and Copper Slag (CS) on the mechanical properties of concrete. Concrete mixtures are made with 10%, 20% and 30% replacement of cement with low lime (class F) fly ash by mass and fine aggregate is replaced by CS from 0 100% with an increment of 20% by volume.

  • UTILIZATION OF COPPER SLAG AS A PARTIAL

    UTILIZATION OF COPPER SLAG AS A PARTIAL REPLACEMENT OF FINE AGGREGATE IN CONCRETE 1. International Journal of Innovative Research in Advanced Engineering (IJIRAE) ISSN: 2349-2763 Issue 10, Volume 3 (October 2016) ijirae _____ IJIRAE

  • Copper slag as sand replacement for high

    Copper slag as sand replacement for high performance concrete. This paper reports on an experimental program to investigate the effect of using copper slag as a replacement of sand on the properties of high performance Proceedings of the 3rd international conference on fly ash, silica fume, slag, and natural pozzolans in concrete, SP

  • Cited by: 177
  • An Experimental Investigation on Partial Replacement of

    Abstract An experimental investigation was performed to study the effect of fly ash and lime on the strength properties of concrete made by partial replacement of cement with fly ash and lime. Various concrete mixtures were prepared with different proportion of fly ash and lime ranging from 0% (for control specimen) to 15%.

  • Effect of copper slag as a fine aggregate on the

    An experimental investigation was conducted to study the effect of using copper slag as a fine aggregate on the properties of cement mortars and concrete. Various mortar and concrete mixtures were prepared with different proportions of copper slag ranging from 0% (for the control mixture) to 100% as fine aggregates replacement.

  • Cited by: 136
  • UTILIZATION OF COPPER SLAG AS A PARTIAL

    UTILIZATION OF COPPER SLAG AS A PARTIAL REPLACEMENT OF FINE AGGREGATE IN CONCRETE 1. International Journal of Innovative Research in Advanced Engineering (IJIRAE) ISSN: 2349-2763 Issue 10, Volume 3 (October 2016) ijirae _____ IJIRAE

  • Mechanical Properties of Concrete with Copper

    This paper presents a laboratory study about the influence of combination of Fly Ash (FA) and Copper Slag (CS) on the mechanical properties of concrete. Concrete mixtures are made with 10%, 20% and 30% replacement of cement with low lime (class F) fly ash by mass and fine aggregate is replaced by CS from 0 100% with an increment of 20% by volume.

  • Replacement of Natural Sand with Efficient Alternatives

    Partial or full replacement of natural sand by the other materials such as fly ash, slag, not only help in 50 % copper slag can be used as replacement of natural sand in to obtain mortar and concrete with required performance, strength and durability.

  • Experimental Study of Partial Replacement of Fine

    Experimental Study of Partial Replacement of Fine Aggregate and Cement with Copper Slag and Fly Ash by Prof. M. P. Bastwadkar after review is found suitable and has been published in Volume 7, Issue X, October 2019 in International Journal for Research in Applied Science & Engineering Technology Good luck for your future endeavors

  • Performance of Copper Slag on Strength as

    Download Citation On Jan 29, 2018, Mansi M. Soni and others published Performance of Copper Slag on Strength as Partial Replacement of Fine Aggregate in Concrete Find, read and cite all the research you need on ResearchGate

  • Fly Ash, Slag, Silica Fume, and Natural Pozzolans, Chapter 3

    Fly Ash, Slag, Silica Fume, and Natural Pozzolans Fly ash, ground granulated blast-furnace slag, silica fume, and natural pozzolans, such as calcined shale, calcined clay be used in addition to or as a partial replacement of portland cement or blended cement in concrete, depending on the

  • What is fly ash and slag? Quora

    Fly Ash is the fine ash that is produced from at coal-fired power plants, which develops cementitious properties when it is mixed with cement & water. Fly ash improves overall quality & performance of concrete. Where Does Fly Ash Come From? A by-p...

  • Concrete without sand? Down to Earth

    7-6-2015· Though she warns that with higher levels of replacements (100 per cent) there might be some bleeding issues and, therefore, she recommended that up to 80 per cent copper slag and ferrous slag can be used as replacement of sand. Bottom ash India is currently producing in excess of 100 million tonnes of coal ash.

  • Durability of Mortar Incorporating Ferronickel Slag

    Abstract: This paper presents the strength and durability of cement mortars using 0–100% ferronickel slag (FNS) as replacement of natural sand and 30% fly ash or ground granulated blast furnace slag (GGBFS) as cement replacement. The maximum mortar compressive strength was achieved with 50% sand replacement by FNS.

  • Engineering Properties of Self-compacting

    This paper illustrates the laboratory investigation results on SCC incorporating, European Federation of National Associations Representing for Concrete (EFNARC) guidelines, by complete replacement of fine aggregates with Processed Slag Sand (PSS) and partial replacement of cement with Class C fly ash.

  • Durability of Mortar Incorporating Ferronickel Slag

    Abstract: This paper presents the strength and durability of cement mortars using 0–100% ferronickel slag (FNS) as replacement of natural sand and 30% fly ash or ground granulated blast furnace slag (GGBFS) as cement replacement. The maximum mortar compressive strength was achieved with 50% sand replacement by FNS.

  • CIVIL EXPERIMENTAL PROJECTS Majestic

    Experimental Investigation on Partial Replacement of Fine Aggregate with Copper Slag Partial Replacement of Cement by Fly Ash and Sand by Marble Dust CEX013. Partial Replacement of Cement with Jute Fibre CEX014. Experimental Investigation on Partial Replacement of Cement by Fly ash and Coarse Aggregate by Sea Shell in Concrete

  • What is fly ash and slag? Quora

    Fly Ash is the fine ash that is produced from at coal-fired power plants, which develops cementitious properties when it is mixed with cement & water. Fly ash improves overall quality & performance of concrete. Where Does Fly Ash Come From? A by-p...

  • Mechanical and Durability Properties of RC Beams Using

    the replacement of 40% of copper slag (by weight) as replacement for fine aggregate. And by the replacement of 20% of fly ash (by weight) as replacement for cement will produce a concrete. Key words: copper slag, fly ash, gfrp. 1.INTRODUCTION Aggregates which are

  • CHAPTER 2 LITERATURE REVIEW Shodhganga

    CHAPTER 2 LITERATURE REVIEW 2.1 GENERAL copper slag as a sand replacement yielded comparable strength to that of the aimed at studying the possible usage of bottom ash (BA) and granulated blast-furnace slag (GBFS) in production of plain concrete elements.

  • A Study on the Strength and Durability of Concrete

    A Study on the Strength and Durability of Concrete with Partial Replacement of Cement by Fly Ash and Fine Aggregates by Copper Slag Journal: International Research Journal of Advanced Engineering and Science (IRJAES) (Vol.2, No. 2) Publication Date: 2017-04-07

  • THE EFFECT OF PARTIAL REPLACEMENT OF CEMENT WITH BONE ASH

    Fly ash is another materials that has been used in partial replacement of cements in concrete and cement mortars, Jo et al. showed that fly ash based lightweightartificial aggregate is (2007) suitable for the production of concrete having a compressive strength of 29 N/mm2. Cold

  • Slag or Flyash What’s the difference? BGC

    Either material can be used as a cement replacement and whether slag and/or flyash is used depends mainly on the application and local availability. Higher addition rates of either slag or flyash usually increase initial setting times and reduce very early strength development when

  • Utilization Of Industrial Waste Copper Slag And

    Read "Utilization Of Industrial Waste Copper Slag And Fly Ash In Concrete, Journal on Structural Engineering" on DeepDyve, the largest online rental service for scholarly research with thousands of academic publications available at your fingertips.

  • Study on the partial replacement of fine aggregate using

    as river sand or manufactured sand. copper slag, recycled aggregates, fly ash aggregate, steel slag etc. The use of Through the present work, the use of induction furnace slag as a partial replacement for the fine aggregate in cement mortar and cement concrete is studied.